What should be paid attention to in the operation of the press

Release time:

2022-07-28 11:14

1. Job arrangement: the person sets the machine, which can be flexibly adjusted according to the production needs, and encourage employees to cultivate spontaneously, and create a good mood and working attitude.
2. Dress code: When entering the workshop, wear a factory label, wear factory clothes, no slippers, bare arms, barefoot operation of the punch bed.
3. Hold the work place: real-time clean up all the table and the work, check whether the seat has any disadvantages, put the half product container; sleeve cuff buckle, except for the operator, mold technician other personnel shall not enter the press workplace.
4. Spot inspection of punch lubrication: check whether the oil storage room of manual lubricating oil pump has sufficient oil storage; if adverse reactions are found, the punishment should be reported to the monitor on duty for real-time disposal punishment to prevent accidents outside production and sale
5. Check whether the mold clip can be accurate, firm and firm, whether there are signs of loosening, and there are no cracks on the blade.
6. Test the punch brake dispersion and user device, make several empty strokes (no flushing product) trial turn, if not the dispersion does not open the motor
7. Prepare the tools you need for work

What is the difference between needle roller bearings and cylindrical bearings

Introduction of ordinary punch press

What is the difference between needle roller bearings and cylindrical bearings

Introduction of ordinary punch press

On November 16, 2024, Grei Electromechanical will celebrate its 25th anniversary, with the event held at the Dalian Golden Sea Pearl Hotel! All employees from the engineering department in Lian attended this event.

2021

11-16

Dalian 40 million large machine tool hoisting project

2021

12-19

What is the difference between needle roller bearings and cylindrical bearings

The needle bearing is equipped with thin and long rollers (roller diameter D 5mm, L / D 2.5, L is the roller length), so the radial structure is compact, its inner diameter size and load capacity are the same as that of other types of bearings, the outer diameter is the minimum, especially suitable for supporting results with limited radial installation size.